Manual download

1. Audi Navigation Plus Installation Phase 1 A6/S6/RS6/allroad For Symphony I Head units model year 1999.5 to 2001 GPS installation TMC/CAN installation and wiring to instrument cluster For Symphony II Head units model year 2002 2004 GPS installation Taping into the speed sensor, illumination and Ignition Power Sources from instrument cluster TMC/CAN installation wiring will come in Phase II Pictures 1a 1n 1a. Nav Plus components and installation stuff 2003/2004 D Navi map disk set Lots of extra connectors, pins/wires etc more than I would need TMC/CAN Gateway and mounting bracket Nav HU Audi Part Audi Part 4B1 919 894 4B0 035 192H GPS antenna ordered from www.gpsaccessories.com Black hockey stick tape Lots of extra pins/wires etc and radio removal tools more than I would ever need Ted Basile teddybgame hotmail.com Updated 7/19/2004 1b. Nav Plus Installation Phase 1 1999.5 2001 A6/S6/allroad Symphony I Homemade TMC/CAN Gateway harness 12 Pin TMC Connector Audi 4A0 972 883 Female pins with wires Audi 000 979 003; only 6 are used 4 Pins go to behind Nav unit CAN H L to Please note There should 26 Pin; battery and be two pins/wires Audi ground to black 8 pin 000 979 003 attached to connector via a these wires. jumper/wire tap 2 Pins to Inst. Cluster Grey Connector to access Radio Shack CAN H Pin 5 and CAN L Pin 6 4 pin harness Item 278 767B Wrapped in hockey stick tape very “OEM like” Please Note In a Symphony I head unit, it will be necessary to use a harness like this one to access the CAN H/L functions from the instrument cluster. In a Symphony II, you can access the CAN H and CAN L from the 20 pin connector, pin 7 and 12, respectively. Ted Basile teddybgame hotmail.com Updated 11/19/2004 1c. Nav Plus Installation Phase 1 Removing the Instrument Cluster 2003 A6 pictured Please Note I highly recommend protecting your steering wheel an