Manual download

Audi R8 V8 Supersport X Pipe Exhaust System Estimated Install Time 6 00 00 Required Tools Commercial Lift or Hydraulic Floor Jack Stands Socket Driver or Impact Wrench 3” Socket Extension Swiveling Socket Adaptor 10mm 13mm Sockets 13mm Open End Wrench T 20, T 25, T 30 Torx Drivers/Bits Flat Head Screwdriver Small Cross Head Screwdriver Snap Ring Pliers Small Flashlight Optional CAUTION Always allow car to cool before performing any installation s or service s on it. Always be sure to work on an even and level surface when raising vehicle s with a jack, and support all raised vehicles with locked jack stands once elevated. Fabspeed Motorsport recommends that all installations be supervised or verified by a trained professional technician. Fabspeed Motorsport is not responsible for any personal injury or damage s sustained to a vehicle during installation of aftermarket performance parts. 1 1. Raise car off of the ground and remove the rear wheels. 2. Remove 7 fasteners securing rear bumper tabs. 3. Remove license plate and 2 fasteners beneath it securing the license plate bracket. 2 4. Locate and remove 2 fasteners tucked up inside of the overhang where the license plate lights are located. 5. Unclip and remove license plate lights. 6. Locate and remove 2 additional fasteners located inside license plate light housings. 3 7. Remove upper rear body panel and unplug all wiring. 8. Remove 2 fasteners from the diffuser channel underneath both sides of the rear bumper assembly. 9. Remove rear underbody inlet covers. 4 10. Remove 4 fasteners near the front center of the rear bumper diffuser panel. 11. Remove 4 fasteners from behind the grilles beneath each tail light. 12. Remove fasteners securing rear upper trim panel. 5